Our staff are street works accredited and fully insured to work deep in the road, which enables us to work with the highways authority. We only need the invert level from the end of the property.

1. We will work out where the main sewer is (foul and surface water), calculate how deep.
2. Check the diameter of the main. This will tell us if you will need to have a saddle or a junction installed.
3. Our street works supervisor will assess the traffic management prior to the work.
4. We will contact the local water authority and arrange for the inspection or installation.
5. Pay all fees due on your behalf to the local water authority prior to the connection.
6. Apply to the highway department for road opening or road closure.
7. Pay all fees due to the local highway department prior to the works.
8. Set up traffic management.
9. Conduct the recommended works from the written quotation.
10.Re-surface the highway.
11.Remove traffic management and re-open the highway.
12.Sewage pump stations could be needed where the drainage of sewage away from properties by gravity is not possible.

Pumping stations with differing capacities are available to pump sewage from different numbers of properties, numbering from just 1 house up to all the properties or a small housing estate. Different systems are available, with single or dual pumps.

Basically we will take complete control and responsibility of the works from start to finish.

Sheet pile walls are constructed by driving prefabricated steel sections into the ground. Soil conditions very often, allow for the sections to be vibrated into ground instead of it being hammer driven. The full wall is had by connecting the joints of adjacent sheet pile sections in sequential installation. Sheet pile walls provide structural resistance. Steel sheet piles are most commonly used in deep excavations. Steel sheet piling is the most common because of several advantages over other materials:
1. Provides high resistance to driving stresses.
2. Light weight.
3. we reused on several projects.
4. Long service life above or below water with modest protection.
5. Easy to adapt the pile length by either welding or bolting.
6. Joints are less apt to deform during driving.

We construct by:
1. Laying out a sequence of sheet pile sections, and ensuring that our sheet piles will interlock.
2. Vibrating the individual sheet piles to the desired depth.
3. Driving the second sheet pile with the interlocks between the first sheet pile and second "locked".
4. Repeating steps 2 & 3 until the wall perimeter is completed.
5. Use connector elements when more complex shapes.

Free Estimates

Pumping Stations

Sheet Piling

We Carry Out All Aspects of Drainage from Small Repairs to Main Public Sewer Connections

Main Public Sewer Pipe

Property Boundary

Inspection Chamber Receiving
waste from property

Main Road

Inspection Chamber prior to connection to the Main Public Sewer

New Sewer Connections - (Domestic and Commercial)

If you have a new or old property and mains drainage (foul or storm water) is possibly available then it is likely that you will require a sewer connection survey or investigation. As most sewers are often in the public highway, any excavation will then come under The New Roads and Street Works Act 1991.

ASL Limited are accredited contractors and we can apply on your behalf to obtain a road opening permit. All the documentation will be carried out by are friendly office staff and we will arrange all necessary inspections.

Main Foul & Storm Sewers

Sewer connections do require initial planning and we would be pleased to offer our advice for your project. We will submit plans on your behalf once we have carried out a survey and search.